Nomoy Pet Controller

Terrarium Thermostat control, for controlling the temperature of your terrarium or vivarium so that your reptile gets the right amount of heat.

• The temperature probe line is 2.4 meters long.
• Maximum load is 1500 watts.
• Temperature control ranges from -9°C to 39°C.
• Size: 9.8cm x 13.8cm

Operating Instructions

The controller turns on/off the power plug based on the measured temperature of the probe.  The center display shows the ambient temperature of the probe.  The left temperature display is the stop temperature at which the controller turns off.  The right temperature display is the start temperature at which controller turns on.

The center switch (开关 —设置) toggles between [RUN] mode and [SETUP] mode.

Programming Instructions

1. Press the center button (开关 —设置) to toggle into [SETUP] mode. The center LED should be on when in [RUN] mode.
2. Now press the temperature “↑” or “↓” buttons on the left side (停止温度) to set the Stop Temp This is the temperature at which the controller is to turn off power to the power plug.  You should see the temperature on the left side of the display change as you press the “↑” or “↓” buttons.  Press and hold to continuously to change the temperature setting.
3. Now press the temperature “↑” or “↓” buttons on the right side (量動温度) to set the Start Temp This is the temperature at which the controller is to turn on power to the power plug.  You should see the temperature on the right side of the display change as you press the “↑” or “↓” buttons.  Press and hold to continuously to change the temperature setting.
4. When both the Stop and Start temperatures have been set, press the center (开关 —设置) button to toggle back into [RUN] mode. The center LED should be on when in [RUN] mode.
5. Once set, and cycled back into [RUN] mode, the set temperatures will be stored and can survive a power off.

Running Mode:

1. When the ambient temperature is at least 1°C below the start temperature, the controller turns on the power plug.
2. If the ambient temperature is 1°C above the stop temperature, the controller turns off the power plug.
3. When the start temperature – 1°C < ambient temperature < stop temperature + 1°C, the power plug will be OFF.